Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Warning: If remote NEs have to be reached from this NE, you need to configure the
Routing Protocol of the TMN-RF channel, if the remote NE is connected through the radio
link or of the NMS Ethernet Port, if the remote NE is connected through the Ethernet cable.
2. Configure the following parameters for each TMN In-Band interface:
3. Configure the Static Routing. Click on the Add Route button to add a static route.
4. Configure the OSPF Areas. Click on the Add Area button to add an OSPF area.
5. Configure NTP servers:
6. Click on the Next button. The next screen to open depends on the configuration.
To configure the Trusted managers screen
1.
− IP address and subnet: default 10.0.3.2/24 for interface #1 and 10.0.4.2/24
for interface #2
− VLAN ID: no default ID for interface #1 and interface #2 (Note: if the two
interfaces are disabled, the VLAN ID will appear in the final report as
undefined).
− List of User Ethernet interfaces where transmit/receive TMN In-Band traffic:
default None (multiple selection with the mouse can be done)
− Routing Protocol: Static Routing or OSPF. The default is Static Routing.
− Area ID in case of OSPF protocol enabled: from 0 to 3
Configuration of the PCP and DSCP fields of the VLAN tag is not supported by
the Provisioning Tool. Default values are applied.
− Put a check mark in the NTP protocol field to enable the protocol.
− In the Main Server address field enter the IP address of the server, which is
in charge to distribute the time to all the NEs in the network.
− In the Spare Server address field enter the IP address of the Spare Server,
if any.
Figure 709
shows the trusted managers screen.
Use the Provisioning Tool
941
Advertisement
Table of Contents
