Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Figure 238
Enable/disable Core-E/P8ETH/EASv2/MSS-O Ethernet port
To disable an Ethernet port
1. Disable Ethernet port (electrical or optical) using the following procedure. See
To provision Ethernet port capabilities parameters
1. Provision Ethernet port capabilities parameters to correspond to the link partner
a. Select Ethernet Port#n to enable (Ethernet Port #1/#8).
b. Select Settings tab.
c. Enable Port Status, select Enabled check box (checked).
d. Click on the Port Status Apply button.
Figure
238.
a. Select Ethernet Port#n to disable (Ethernet Port #1/#8).
b. Select Settings tab.
c. Disable Port Status, select Enabled check box (not checked).
d. Click on the Port Status Apply button.
using the following procedure. See
Provision Ethernet ports
Figure
239.
413
Advertisement
Table of Contents
