Sdh To Radio; Prerequisites - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
Provision cross connections
The Service Profile on each E1/DS1/DS3 card Settings screen must be set to
TDM2TDM for each E1/DS1/DS3 cross connect when both termination points of the
E1/DS1/DS3 circuit are terminated on 9500 MPR equipment.
The Service Profile on each E1/DS1/DS3 card Settings screen must be set to
TDM2ETH for each E1/DS1/DS3 cross connect when one of the termination points
of the E1/DS1/DS3 circuit are terminated on non-9500 MPR equipment, and the
other equipment is MEF-8 compliant.
Each E1/DS1/DS3 line to be cross connected must have a unique Flow ID number
assigned to it on the respective E1/DS1/DS3 card Settings screen.
Verify appropriate port segregation is provisioned to prevent message flooding. Port
segregation should be provisioned between parallel radio paths at both ends when
they exist on the NE. Port segregation should also be provisioned between the radio
port and other Ethernet and/or radio ports where connectivity is not desirable.

43.4 SDH to radio:

Caution: In the protected Core configuration, entering SDH cross-connections while the
spare Core is Active may affect existing SDH cross-connections. To prevent this from
occurring, ONLY provision SDH cross-connections while the main Core card is Active.
Caution: When parallel radio paths exist between two MSS shelves, port segregation
should be provisioned between the parallel radio paths at both ends to prevent a loss of
traffic.

43.4.1 Prerequisites

Each SDH port and radio port must be enabled on the respective SDH card and
Core/MPTACC/P8ETH/EASv2 card or MPT-HC/XP/HC-HQAM/XP-HQAM/9558HC
Radio L1 LAG port provisioning screens.
The Service Profile on all SDH card Settings screen must be set to SDH2SDH for
each SDH cross connect.
Each SDH line to be cross connected must have a unique Flow ID number assigned
to it on the respective SDH card Settings screen.
350
WebEML User Manual