Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Figure 429
Node I to NE G: Ethernet-PDH cross-connection on NE G
2. Configure an Ethernet-Ring cross-connection on Node C, see
e. Choose the flow ID from the Flow Id drop-down
f. Configure the payload size, ECID Tx, and ECID Rx parameters
g. Choose the Service profile: TDM2TDM or TDM2ETH
h. Choose the TDM clock source, if the Service profile is TDM2ETH
i. Enter the MAC address: Node A Unicast MAC address
Provision cross connections in a mixed fiber/
microwave Ring
Figure
430.
619