Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Note: The Channel #1 Rx Freq (KHz) field displays the Rx RF Frequency and is the result
of the following calculation:
RX Frequency = TX Frequency - Shifter Frequency
Note: In a Protected MPT-HC/HQAM configuration, the Main and Protect MPT-HC/HQAM
cards use the same CT screen. The parameters on the Spare (Channel #0) part of the
screen is a mirror image of the Main (Channel #1) part of the screen. Channel #0 fields will
be automatically populated to match Channel #1.
44. Select an action.
45. Provision the MPT ODU 1+1 FD spare radio channel
viii. When the radio is connected to the MSS shelf, the Channel #1 TxFreq(KHz)
field is automatically populated. If the radio is not connected, enter the TX
RF Frequency within the allowed range.
ix. The Rx Freq (KHz) displays the Rx RF Frequency.
x. Enter the radio channel User Label, if applicable.
xi. Click Apply.
a. To
Provision the MPT ODU 1+1 FD spare radio
b. To
Provision the MPT ODU Manual Transmit Power Level
step 48.
c. To
Provision the MPT ODU Automatic Transmit Power Control
to step 53.
Open the appropriate radio main view depending on your radio configuration
and select the Settings tab; see
Configure radio parameters
channel, go to step
Figure
652.
45
(RTPC), go to
(ATPC), go
867
Advertisement
Table of Contents
