Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
System Aggregation Priority:
The System Aggregation Priority of each System is an eight octet binary number.
The System with the numerically lower value of System Aggregation Priority has the
higher priority.
A LAG system supporting LACP, dynamically assigns the member ports of the LAG
group. Starting with the highest priority port to the lowest priority ports. At the remote
end of the same LAG link, there is another system that wants also to assign the ports
to the LAG group according to its own port priorities. And here two systems propose
two different port assignments for the same LAG group. And it's the system with the
highest system priority that overrides the link and imposes its port assignment.
22.2.6 AIS insertion for LOF detection on DS1 (ANSI
The AIS insertion for Loss Of Frame (LOF) detection on DS1 provisions NE behavior
upon detection of LOF on DS1 inputs and outputs. This provisioning is applicable for
all DS1 ports enabled on the MSS-4/8 shelf.
By enabling AIS insertion for LOF detection on DS1 feature, AIS is inserted for the
following conditions:
By disabling AIS insertion for LOF detection on DS1 feature, AIS is not inserted for
the following conditions
22.2.7 Event and alarm log
To enable event and alarm logging, select enabled in the Event and Alarm Log
Logging drop-down menu.
• [0 - 1 bytes] System Priority
• [2 - 7 bytes] NE MAC address
market only)
• Loss Of Frame detection on DS1 facilities incoming from the demarcation panel
• Loss Of CESoETH Frame detection on DS1 facilities from the switch matrix
• Loss Of Frame detection on DS1 facilities incoming from the demarcation panel
• Loss Of CESoETH Frame detection on DS1 facilities from the switch matrix
Administer system settings
175
Advertisement
Table of Contents
