Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
Configure radio parameters
To administer the MPT ODU
1. Select an action.
2. Provision the MPT ODU power scheme
Note: MPT ODU power scheme provisioning applies to MPT ODUs enabled on the
MPTACC card, MSS-1 Core with PFoE support, EASv2 with PFoE support, or MSS-O with
PFoE support.
848
ii. Click Apply.
a. To
Provision the MPT ODU power
b. To
Provision the MPT ODU co-channel XPIC
c. To
Provision the MPT ODU 1+1 XPIC
d. To
Provision the MPT ODU radio protection
e. To
Provision the radio for fixed
f. To
Provision the radio for Adaptive
g. To
Provision the MPT ODU 1+1 FD spare radio
h. To
Provision the MPT ODU Manual Transmit Power Level
step 48.
i. To
Provision the spare MPT ODU
j. To
Provision the MPT ODU Automatic Transmit Power Control
to step 53.
k. To
Provision the spare MPT ODU
l. To
Provision the MPT ODU radio protection
m. To
Provision the MPT ODU link
n. To
Provision the MPT ODU Synchronization Status
step 68.
o. To
Provision the MPT ODU Point to Point Protocol
p. To
Provision the PKT throughput booster
q. To
Administer the MPT ODU Alarm Profile
r. To
Provision the MPT ODU radio channel
s. To
Configure the Low Voltage Alarm for the
Provision MPT ODU power scheme
WebEML User Manual
scheme, go to step 2.
configuration, go to step 7.
configuration, go to step 18.
type, go to step 29.
modulation, go to step 39.
Modulation, go to step 42.
channel, go to step 45.
RTPC, go to step 51.
ATPC, go to step 56.
scheme, go to step 58.
identifier, go to step 66.
Messaging, go to
settings, go to step 69.
setting, go to step 70.
settings, go to step 71.
encryption, go to step 72.
MPT-HQAM, go to step 73.
(RTPC), go to
(ATPC), go
Advertisement
Table of Contents
