Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Caution: When parallel radio paths exist between two MSS shelves, port segregation
should be provisioned between the parallel radio paths at both ends to prevent a loss of
traffic.
43.7.1 Prerequisites
The E1/DS1/DS3 card (source) and Core, P8ETH or EASv2 card (destination) must
be enabled on the respective E1/DS1/DS3 card, and Core, P8ETH or EASv2 card or
Ethernet LAG port provisioning screens.
The Service Profile on the E1/DS1/DS3 card Settings screen must be set to
TDM2ETH for each E1/DS1/DS3 cross connected.
Verify appropriate port segregation is provisioned to prevent message flooding. Port
segregation should be provisioned between parallel radio paths at both ends when
they exist on the NE. Port segregation should also be provisioned between the
Ethernet port and other Ethernet and/or radio ports where connectivity is not
desirable.
43.8 Ethernet to radio:
Caution: When parallel radio paths exist between two MSS shelves, port segregation
should be provisioned between the parallel radio paths at both ends to prevent a loss of
traffic.
43.8.1 Prerequisites
The Ethernet port (source) and radio port (destination) must be enabled on the
respective Core, MPTACC, EAS card, or Ethernet/Radio LAG port provisioning
screens.
Ranging Flow ID entry is supported.
Provision cross connections
353
Advertisement
Table of Contents
