Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
Figure 186
Sync Ports with Sync-In/Out SFP
22. Go to step 29.
23. From the E1/DS1 Port drop-down menu, select the E1/DS1 Port.
24. Go to step 29.
25. From the Eth Port drop-down menu, select the Eth Port.
26. Go to step 29.
27. From the STM-1/OC-3 Port drop-down menu, select the STM-1/OC-3 Port.
28. Go to step 29.
29. Provision Sync Out Port?
30. In the Sync Ports partition, from the Sync Out Port drop-down menu, select the
31. In the Wait-To-Restore time entry boxes select the wait to restore time in
a. If yes, go to step 30.
b. If no, go to step 31.
Sync Out Port frequency: 1.024 MHz, 2.048 MHz, 5 MHz, or 10 MHz.
Note: If a Sync-In/Out SFP is in use, the Sync Ports area is labeled Sync In/Out
SFPs. The Sync Out Port appears as NOT USED. The SFP is displayed as Sync
Out Port #5, #6, #7, #8, depending on where the SFP is placed; see
minutes (min.) [0-12] and seconds (sec.) [0, 10, 20, 30, 40, 50].
Administer synchronization
Figure
186.
339
Advertisement
Table of Contents
