Table of Contents
Advertisement
Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
3. Which card supports MPT ODU radio port?
4. Open the appropriate radio main view.
5. Provision MPT ODU power source:
Note: QMA is available with MPTACC only.
For MPT ODU enabled on a Core Ethernet port, P8ETH Ethernet port, EASv2
without PFoE support, or an MSS-1 Core without PFoE support, an external
source of power is required. The external source may be either a Power Injector
card/Box. MPT Power Unit, MPT Extended Power Unit, or direct connection to
an external battery source. In these applications no power scheme provisioning
is required.
a. If MPTACC, MSS-1 port with PFoE support, EASv2 with PFoE support, or
MSS-O with PFoE support, go to step 4.
b. If Core-E, CorEvo, P8ETH, EASv2without PFoE support, or MSS-1 port
without PFoE support, MPT ODU power scheme provisioning is not
required. Go to step 6.
See
Figure 635
for the following steps:
i. Select Power Source.
ii. Select the Source # in the resource tree area. The selected name will
highlight in blue. This selection also highlights the Source Number in blue in
the resource list area.
iii. Choose the Settings tab.
iv. From the Source x area, select Power Source 1/2 Type radio button: QMA,
PFoE, or Disabled.
v. Click Apply.
Configure radio parameters
849
Advertisement
Table of Contents
