Figure 200 Pdh To Ethernet Cross Connection - Nokia 9500 MPR User Manual

Release 7.0.0 3DB 19286 ACAA Issue 01
WebEML User Manual
1. Verify port segregation provisioning. Port segregation should be provisioned
2. Select PDH port and drag to draw line to ETH port.
Figure 200 PDH to Ethernet Cross Connection
3. On the PDH-Eth pop-up, select Flow ID number from Flow ID drop-down list.
4. Enter the destination MAC address where the PDH will be terminated in the
Note: The first two digits of the destination MAC address for unprotected ports must be set
to 'unicast' or '00'. The first two digits of the destination MAC address for 1+1 protected and
L1 LAG ports must be set to 'multicast' or '01'. The first two digits of the destination MAC
address for all ERPS ring nodes must be set to 'unicast' or '00'
between parallel radio paths at both ends when they exist on the NE. Also port
segregation should be provisioned between the Ethernet port and other Ethernet
and/or radio ports where connectivity is not desirable. See
segregation/connectivity
PDH-ETH pop-up displays. See
MAC Address field.
for detailed steps to view/provision port segregation.
Figure 200.
Provision cross connections
Provision port
365