Sti: Defining A Station Id - Magellan ProFlex 500 Reference Manual

STI: Defining a Station ID

Function
Command Format
Relevant Query
Command
See also
This command is used to define the station ID the base
receiver will broadcast in its messages to the rover. The
format of the station ID depends on the message type in
which it is included.
Syntax
$PASHS,STI,s[*cc]
Parameters
Parameter Description
s Station ID
*cc Optional checksum
Examples
Defining station ID "150" for use in RTCM messages:
$PASHS,STI,150*23
Note
If the station ID is not a pure number, as required for RTCM,
CMR and CMR+ messages, then it is transformed into a pure
number (example: "ST56" becomes "56"). If the resulting
number is out of bounds, then the maximum value in the
applicable range is chosen instead (e.g. "31" instead of "56"
if CMR messages are broadcast).
$PASHQ,STI
$PASHS,BAS
$PASHS,MOD,BAS
Range
0-1023 (RTCM 2.3)
0-4095 (RTCM 3.x)
0-31 (CMR & CMR+)
*00-*FF
Set Command Library
177