Table of Contents
Advertisement
Set Command Library
Relevant Query
Commands
See Also
ANP,REF: Naming the Antenna Used at the Base
Function
Command Format
104
Parameters
Parameter
User-defined antenna name (case-sensitive).
s1
Default name is "UNKNOWN"
s2
Antenna serial number
d3
Antenna setup ID
*cc
Optional checksum
Comments
• Specifying the antenna name allows the receiver to know
where to find the antenna offset parameters. In the
receiver, the predefined parameters can be listed using
$PASHQ,ANP. New offset parameters can be added using
$PASHS, ANP,PCO.
• The predefined list complies with the IGS antenna source
table.
• The antenna name (and the optional serial number and
setup ID) are also inserted into the RTCM antenna
message when the receiver is used as a base.
Example
Entering "MAG111406" as the name of the receiver
antenna:
$PASHS,ANP,OWN,MAG111406*34
$PASHQ,ANP,OWN
$PASHQ,ANP,REF
$PASHQ,ANP
$PASHS,ANP,REF
This command is used to enter the name of the antenna used
by the base the receiver is working with.
Syntax
$PASHS,ANP,REF,s1[,s2][,d3][*cc]
Description
Range
31 characters max.
31 characters max.
0-255
*00-*FF
Advertisement
Table of Contents
