Nme: Enabling/Disabling Nmea Messages - Magellan ProFlex 500 Reference Manual

NME: Enabling/Disabling NMEA Messages

Function
Command Format
This command is used to enable or disable NMEA messages
and Magellan NMEA-like messages.
Syntax
$PASHS,NME,s1,c2,s3[,f4][*cc]
Parameters
Parameter
s1 Data message type
• A, B, F: Serial port
• C: Bluetooth
c2 • I: Ethernet
• E: Modem
• M, U: Memory
Enables (ON) or disables (OFF) the mes-
s3
sage
Output rate:
• or 1-999: Output rate in seconds
f4
• Omitted: The message output rate will be
as defined with $PASHS,NME,PER
*cc Optional checksum
NMEA messages:
Data
ALM GPS almanac data
GGA GPS fix data
GLL Geographic position - Latitude / Longitude
GRS GNSS range residual
GSA GNSS DOP and active satellites
GST GNSS pseudo-range error statistics
GSV GNSS satellites in view
RMC Recommended minimum specific GNSS data
VTG Course over ground and ground speed
ZDA Time and date
Magellan NMEA-like messages:
Data
CRT Cartesian coordinates
DCR Delta cartesian
Description
Description
Description
Set Command Library
Range
See tables below
A, B, C, E, F, I, M,
U
ON, OFF
0.1-0.9 s
1-999 s
*00-*FF
147