Table of Contents
Advertisement
RDP,PAR: Setting the Radio
Function
Command Format
This command is used to set the radio connected to the
specified port.
Syntax
$PASHS,RDP,PAR,c1,s2,c3[,s4][,c5][,c6][,s7][*cc]
Parameters
Parameter
ID of the port connected to the radio you want
c1
to set.
Radio Model:
s2
• MGL: Magellan UHF
• PDL: Pacific Crest
c3
Channel number
Power management (if port D is used)
s4
• AUT: Automatic
• MAN: Manual
Protocol used (if a PDL radio model is used)
• 0: Transparent
c5
• 1: TRIMTALK
• 2: DSNP
PDL Air link speed:
• 4800: 4800 Bd, GMSK modulation
• 9600: 9600 Bd, GMSK or four-level FSK
c6
modulation
• 19200: 19200 Bd, four-level FSK modula-
tion
s7
Radio sensitivity (PDL only)
*cc
Optional checksum
Comments
The command will be NAKed if the receiver has not been told
the radio is on the port specified by command
$PASHS,RDP,TYP.
The air link speed depends on the type of modulation used
(GMSK or four-level FSK) as well as the channel spacing
used.
Description
Set Command Library
Range
A, B, D, F
PDL, MLG (port A)
PDL (Ports B, F)
PDL (port D)
0-15
AUT, MAN
0-2
4800, 9600, 19200
LOW, MED, HIG
*00-*FF
167
Advertisement
Table of Contents
