Table of Contents
Advertisement
Chapter 15. Troubleshooting
Bluetooth Connection from FAST Survey Failed
Bluetooth Icon::
Step 1. Has your
Receiver Booted
Normally?
RTK Base
Relevant to
•
Your field terminal typically uses a wireless link (Bluetooth
type) to communicate with the receiver.
To ask for a Bluetooth connection with a receiver, you have to
select "Bluetooth" and "Magellan BT" on the Comms tab
when setting your base or rover. Using the Configure button,
you can then search for remote Bluetooth-enabled devices,
select the one corresponding to your receiver and finally ask
for a Bluetooth connection to be established between FAST
Survey and your receiver.
In the next sessions, FAST Survey will automatically restore
the connection if you ask it to do so, provided the same
receiver is still close by and powered on.
When the Bluetooth connection is active, the Bluetooth icon
is displayed in the lower-right corner of the screen.
After examining the screen, you determine that FAST Survey
is not communicating with the receiver via Bluetooth. Follow
the steps below to try to resolve the problem.
When you turn on your receiver, it may fail to complete the
boot sequence.
1. If your receiver has completed the boot sequence normally
(the General Status screen is displayed after the
"Starting..." message), go to Step 2.
2. If your receiver fails to complete the boot sequence:
• Make sure the battery is charged. A too-low battery will
prevent the receiver from powering up normally.
RTK Rover
PP Base
•
•
PP Rover
•
353
Advertisement
Table of Contents
