Table of Contents
Advertisement
Chapter 6. Post-Processed Surveying
System Setup
Base Setup
Rover Setup
This setup should always be used for a base and may also be
used for a rover having to run a static survey.
Prerequisites:
• You need accessories to install the base, such as a tripod,
a tribrach and an antenna pole.
• Allow for an external DC power source if this is how you
want the base to be powered. Connect the power source to
the DC Power Input located underneath the unit.
Step-by-step Procedure:
1. Set up the tripod and tribrach over the point chosen for
the base.
2. Secure the ProFlex 500 on the tripod.
3. Insert the antenna pole into the tribrach.
4. Perform a slant height measurement. Keep the measured
value in your mind or write it down.
This setup is intended for rovers having to run continuous or
stop&go kinematic surveys.
Prerequisites:
73
Advertisement
Table of Contents
