Table of Contents
Advertisement
Logging Points in Continuous Mode
Used to
pause/resume data
logging
Used to log a point's
position manually
Current status of
position solution
Point ID incremented
automatically
Current position and
related quality figures
1. On the Survey tab, select the Auto by Interval function. Two
different modes are possible: Time or Distance.
2. If you choose Distance, enter the horizontal and vertical
increment value respectively in the X/Y and Z fields,
according to the chosen unit. If you choose Time, enter the
increment value, in seconds.
3. Enter a point Id. for the start point in the Starting Pt ID
field. This field will be incremented by one after each
point logging. You do not need to define a name finishing
with a figure. FAST Survey will place one anyway when
incrementing this field.
4. Tap
to switch to the graphic screen (see figure below)
and start logging the first point.
Zoom settings
The S button lets you instantly log the position of a point.
The pause button allows you to pause data logging in
continuous mode.
If data logging in continuous mode is paused, you can still
continue to log points in manual mode using the S button.
Tap the pause button again to resume data logging in
continuous mode.
If you directly tap
data logging in continuous mode is automatically stopped.
Configures general
case of point logging
Provides access to
monitor screen
Your current position
and heading
Graphic display area
GNSS antenna height
Viewing parameters
to come back to the main menu,
RTK Surveying
67
Advertisement
Table of Contents
