Table of Contents
Advertisement
Post-Processed Surveying
Continuous Kinematic Survey
82
14.Tap on the File Manager button. You should recognize the
last file in the list as the file you have just closed (the file
is identified by the point name you last entered).
Your rover is located at the beginning of the trajectory. Do the
following to run the survey:
1. Tap on the Survey tab and then on Log Raw GPS.
2. Tap on Start File. The screen lists the currently used
settings.
3. Keep or edit these settings, depending on the specific
requirements of your survey:
• Elev Mask: Elevation mask, in degrees (default: 5
degrees)
• Antenna Height: Current value of antenna height,
expressed in the chosen unit. Use the Change Ant.
button to change the antenna height. Choose the
measurement type first (Vertical or Slant) and then enter
the measured value.
•
Choose the storage medium where to store the file
(Internal Mem or USB Mem Stick).
• Interval: Raw data recording rate, in seconds. Use the
same recording rate as the base.
. On top of the screen now appears the Logging...
4. Tap
message indicating raw data recording in progress. A
default name is given to the open raw data file, based on
the naming conventions described in ATOM File Naming
Conventions on page 373.
5. As you start walking along the trajectory, you can name it.
According to the same ATOM file naming conventions,
naming this trajectory will impact the raw data filename.
To name the trajectory, tap on the Tag New Site button. This
opens a new window on which you can enter the following
parameters:
• Site Name: Enter a name for the trajectory. A four-
character name is recommended so that the entire
name, and not a truncated name, appears later in the
raw data file name. Longer site names will not be
truncated however in GNSS Solutions.
Advertisement
Table of Contents
