Table of Contents
Advertisement
RTK Configuration Steps
RTK Base Configuration
Prerequisites
Set Manufacturer
& Model
Check/Change
Bluetooth
Connection
38
• Your base is properly set up and powered on. It is on its
definitive location for the survey and the field terminal is
located at less than 10 metres from the base.
• Your field terminal is on, FAST Survey is running, a
Bluetooth connection has already been configured (with
the base; see How FAST Survey Interfaces With Your
Equipment Via Bluetooth on page 29) and a job file is
open.
• In FAST Survey, tap on the Equip tab and then the GPS
Base button. A message may appear asking you to confirm
your choice of configuring a base. Tap Yes. This opens the
Current tab of the GPS Base window.
• Set the Manufacturer ("Magellan Navigation") and Model
("ProFlex 500") of the equipment used as the base.
• Tap on the Comms tab. Since the Bluetooth connection
was performed earlier, just check that FAST Survey is
properly configured to communicate with the base. You
should read:
• Type = "Bluetooth"
• Device = "Magellan BT"
• Instr = should be set to the name you gave earlier to the
base, as seen from FAST Survey Bluetooth.
Note that the Configure button next to the Device field
allows you to return to the Bluetooth Devices window
through which you earlier configured the Bluetooth
connection to the base (see How FAST Survey Interfaces
With Your Equipment Via Bluetooth on page 29). Changes
can be made now if necessary.
Advertisement
Table of Contents
