Table of Contents
Advertisement
Post-Processed Surveying
"Stop & Go" Kinematic Survey
80
7. Tap on the Monitor/Satellite View button to make sure GNSS
reception is good at the survey point (enough satellites are
received, DOP values low). Ignore all RTK-related
indicators.
8. Tap
to return to the previous screen.
9. Wait until the end of the countdown. A message then
informs you that the programmed time of data collection
has elapsed.
10.Tap OK to acknowledge the message.
11.Tap on the Close File button to end data collection and
close the raw data file.
12.Tap on the File Manager button. You should recognize the
last file in the list as the file you have just closed (the file
is identified by the point name).
The rover is located on the first survey point. Follow the
instructions below to run the survey:
1. Tap on the Survey tab and then on Log Raw GPS.
2. Tap on Start File. The screen lists the currently used
settings.
3. Keep or edit these settings, depending on the specific
requirements of your survey:
• Elev Mask: Elevation mask, in degrees (default: 5
degrees)
• Antenna Height: Current value of antenna height,
expressed in the chosen unit. Use the Change Ant.
button to change the antenna height. Choose the
measurement type first (Vertical or Slant) and then enter
the measured value.
•
Choose the storage medium where to store the file
(Internal Mem or USB Mem Stick).
• Interval: Raw data recording rate, in seconds. Use the
same recording rate as the base.
. On top of the screen now appears the Logging...
4. Tap
message indicating raw data recording in progress. A
default name is given to the open raw data file, based on
the naming conventions described in ATOM File Naming
Conventions on page 373.
5. Name the point where data collection is taking place.
According to the same ATOM file naming conventions,
Advertisement
Table of Contents
