Table of Contents
Advertisement
RTK Rover Configuration
Prerequisites
Set Manufacturer
& Model
Set Bluetooth
Connection
Set Receiver
Parameters
• Your rover is properly set up and powered on.
• Your field terminal is on, FAST Survey is running and a job
file is open.
• In FAST Survey, tap on the Equip tab and then the GPS
Rover button. A message may appear asking you to
confirm your choice of configuring a rover. Tap Yes. This
opens the Current tab of the GPS Rover window.
• Set the Manufacturer ("Magellan Navigation") and Model
("ProFlex 500") of the equipment used as the rover.
• Tap on the Comms tab.
• In the Type field, select "Bluetooth".
• In the Device field, select "Magellan BT".
• Tap on the Configure button to access the Bluetooth
Devices window. The window lists Bluetooth identifiers
that correspond to the receivers found in the vicinity.
• Select the rover's Bluetooth identifier from the list. To
make sure you are making the right selection, press the
Scroll button on your rover until you display the Receiver
Identification screen. The Bluetooth identifier is shown in
the lower line. This is the parameter you must select from
the list.
You may give the rover a more familiar name (e.g.
"MyRover") using the Set Receiver Name button.
• Tap
to connect the field terminal to the rover via
Bluetooth. FAST Survey then returns to the GPS Rover
configuration window.
• Check that the rover name is now selected in the Instr
field.
• Measure or read the length of the range pole on top of
which the ProFlex 500 is mounted.
RTK Configuration Steps
45
Advertisement
Table of Contents
