Delta C200 Series User Manual page 79

Call 1(800)985-6929 for Sales
03 Analog Input/Output Parameters
Parameter
Analog Input Selection
03-00
(AVI)
Analog Input Selection
03-01
(ACI)
Analog Input Selection
03-02
(AUI)
03-03 Analog Input Bias (AVI)
03-04 Analog Input Bias (ACI)
Analog Positive Voltage
03-05
Input Bias (AUI)
03-06 Reserved
Positive/negative Bias
03-07
Mode (AVI)
Positive/negative Bias
03-08
Mode (ACI)
Positive/negative Bias
03-09
Mode (AUI)
Analog Frequency
03-10 Command for Reverse
Run
03-11 Analog Input Gain (AVI)
03-12 Analog Input Gain (ACI)
Analog Positive Input
03-13
Gain (AUI)
Analog Negative Input
03-14
Gain (AUI)
Analog Input Filter Time
03-15
(AVI)
Analog Input Filter Time
03-16
(ACI)
Analog Input Filter Time
03-17
(AUI)
Addition Function of the
03-18
Analog Input
03-19 ACI Signal Loss
Multi-function Output 1
03-20
(AFM1)
Call 1(800)985-6929 for Sales
deltaacdrives.com
Explanation Settings
0: No function
1: Frequency command (torque limit under torque
control mode)
2: Torque command (torque limit under speed mode)
3: Torque compensation command
4: PID target value
5: PID feedback signal
6: PTC thermistor input value
7: Positive torque limit
8: Negative torque limit
9: Regenerative torque limit
10: Positive/negative torque limit
-100.0~100.0%
-100.0~100.0%
-100.0~100.0%
0: No bias
1: Lower than or equal to bias
2: Greater than or equal to bias
3: The absolute value of the bias voltage while serving
4: Serve bias as the center
0: Negative frequency is not valid. Forward and
1: Neagtive frequency is valid. Positive frequency =
-500.0~500.0%
-500.0~500.0%
-500.0~500.0%
-500.0~500.0%
0.00~20.00 sec.
0.00~20.00 sec.
0.00~20.00 sec.
0: Disable (AVI, ACI, AUI)
1: Enable
0: Disable
1: Continue operation at the last frequency
2: Decelerate to 0Hz
3: Stop immediately and display ACE
0: Output frequency (Hz)
deltaacdrives.com
Chapter 10 Summary of Parameter Settings|C200 Series
as the center
reverse run is controlled by digital keypad or
external terminal.
forward run; negative frequency = reverse run.
Direction can not be switched by digital keypad or
external teriminal control.
10-11
sales@deltaacdrives.com
Factory
Setting
1
0
0
0
0
0
0
0
100.0
100.0
100.0
100.0
0.01
0.01
0.01
0
0
0
sales@deltaacdrives.com