Delta C200 Series User Manual page 302

Call 1(800)985-6929 for Sales
The vibrating circuitry of cycle time ΔT (On) +ΔT (Off):
X0 Y1
T0
The figure above uses timer T0 to control coil Y1 to be ON. After Y1 is ON, timer T0 will be
closed at the next scan period and output Y1. The oscillating circuit will be shown as above. (n is
the setting of timer and it is decimal number. T is the base of timer. (clock period))
Example 8: Blinking Circuit
X0 T2
T1
X0 T1
The figure above is common used oscillating circuit for indication light blinks or buzzer alarms. It
uses two timers to control On/OFF time of Y1 coil. If figure, n1 and n2 are timer setting of T1 and T2.
T is the base of timer (clock period)
Example 9: Triggered Circuit
X0
M0
M0
In figure above, the rising-edge differential command of X0 will make coil M0 to have a single
pulse of ΔT (a scan time). Y1 will be ON during this scan time. In the next scan time, coil M0 will be
OFF, normally close M0 and normally close Y1 are all closed. However, coil Y1 will keep on being
ON and it will make coil Y1 to be OFF once a rising-edge comes after input X0 and coil M0 is ON
for a scan time. The timing chart is as shown above. This circuit usually executes alternate two
actions with an input. From above timing: when input X0 is a square wave of a period T, output coil
Y1 is square wave of a period 2T.
Example 10: Delay Circuit
X0
T10
When input X0 is ON, output coil Y1 will be ON at the same time due to the corresponding
normally close contact OFF makes timer T10 to be OFF. Output coil Y1 will be OFF after delaying
100 seconds (K1000*0.1 seconds =100 seconds) once input X0 is OFF and T10 is ON. Please
refer to timing chart above.
Call 1(800)985-6929 for Sales
TMR T0
Y1
TMR T1 Kn1
TMR T2 Kn2
Y1
M0
Y1
Y1
Y1
TMR T10 K1000
Y1
TB = 0.1 sec
deltaacdrives.com
X0
Kn
Y1
X0
Y1
X0
M0
Y1
X0
Y1
14-17
deltaacdrives.com
sales@deltaacdrives.com
Chapter 14 PLC Function |C200 Series
n T T
n2 * T
T
n1 *
T
100 seconds
sales@deltaacdrives.com