Delta C200 Series User Manual page 294

Call 1(800)985-6929 for Sales
14.4 Ladder Diagram
14.4.1 Program Scan Chart of the PLC Ladder Diagram
Calculate the result by
ladder diagram
algorithm (it doesn't
sent to the outer output
point but the inner
equipment will output
immediately.)
14.4.2 Ladder Diagram
Ladder diagram is a diagram language that applied on the automatic control and it is also a
diagram that made up of the symbols of electric control circuit. PLC procedures are finished
after ladder diagram editor edits the ladder diagram. It is easy to understand the control flow
that indicated with diagram and also accept by technical staff of electric control circuit. Many
basic symbols and motions of ladder diagram are the same as mechanical and electrical
equipments of traditional automatic power panel, such as button, switch, relay, timer, counter
and etc.
The kinds and amounts of PLC internal equipment will be different with brands. Although
internal equipment has the name of traditional electric control circuit, such as relay, coil and
contact. It doesn't have the real components in it. In PLC, it just has a basic unit of internal
memory. If this bit is 1, it means the coil is ON and if this bit is 0, it means the coil is OFF. You
should read the corresponding value of that bit when using contact (Normally Open, NO or
contact a). Otherwise, you should read the opposite sate of corresponding value of that bit
when using contact (Normally Closed, NC or contact b). Many relays will need many bits, such
as 8-bits makes up a byte. 2 bytes can make up a word. 2 words make up double word. When
using many relays to do calculation, such as add/subtraction or shift, you could use byte, word
Call 1(800)985-6929 for Sales
deltaacdrives.com
Read input state from outside
X0 X1
Start
Y0
X10
M100 X3
:
:
X100 M505
Send the result to the output point
14-9
deltaacdrives.com
Chapter 14 PLC Function |C200 Series
Y0
Repeats the
Y1
execution in
cycle.
Y126
End
sales@deltaacdrives.com
sales@deltaacdrives.com