Delta C200 Series User Manual page 190

Call 1(800)985-6929 for Sales
104: CbFE CANopen hardware disconnect
105: CIdE CANopen index setting error
106: CAdE CANopen slave station number
setting error
107: CFrE CANopen index setting exceed limit
108~110: Reserved
111: InrCOM Internal communication overtime
error
PTC (Positive Temperature Coefficient) Detection Selection
Settings 0: Warn and keep operating
Pr.06-29 setting defines how the will drive operate after PTC detection.
PTC Level
Settings 0.0~100.0%
It needs to set AVI/ACI/AUI analog input function Pr.03-00~03-02 to 6 (P.T.C. thermistor input
value).
It is used to set the PTC level, and the corresponding value for 100% is max. analog input value.
Frequency Command for Malfunction
Settings 0.00~655.35Hz
When malfunction occurs, use can check the frequency command. If it happens again, it will
overwrite the previous record.
Output Frequency at Malfunction
Settings 0.00~655.35Hz
When malfunction occurs, use can check the current frequency command. If it happens
again, it will overwrite the previous record.
Output Voltage at Malfunction
Settings 0.0~6553.5V
When malfunction occurs, user can check current output voltage. If it happens again, it will
overwrite the previous record.
DC Voltage at Malfunction
Call 1(800)985-6929 for Sales
deltaacdrives.com
Fault Code
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
deltaacdrives.com
Chapter 11 Description of Parameter Settings|C200 Series
Bit0 Bit1 Bit2
current Volt. OL
11-91
sales@deltaacdrives.com
Bit3 Bit4 Bit5 Bit6
SYS FBK EXI CE
Factory Setting: 0
Factory Setting: 50.0
Factory Setting: Read only
Factory Setting: Read only
Factory Setting: Read only
sales@deltaacdrives.com
●
●
●
●
●