Delta C200 Series User Manual page 187

Call 1(800)985-6929 for Sales
62: Decel. Energy Backup Error (dEb)
63: Slip error (oSL)
64: Electromagnet switch error (ryF)
65 : PG Card Error (PGF5)
66-78: Reserved
79: Uocc U phase over current (Detection begins as RUN is pressed,
80: Vocc V phase over current (Detection begins as RUN is pressed,
81: Wocc W phase over current (Detection begins as RUN is pressed,
82: OPHL U phase output phase loss
83: OPHL Vphase output phase loss
84: OPHL Wphase output phase loss
85~100: Reserved
101: CGdE CANopen software disconnect1
102: CHbE CANopen software disconnect2
103: CSYE CANopen synchronous error
104: CbFE CANopen hardware disconnect
105: CIdE CANopen index setting error
106: CAdE CANopen slave station number setting error
107: CFrE CANopen index setting exceed limit
108~110: Reserved
111: InrCOM Internal communication overtime error
When th
e fault occurs and force stopping, it will record in this parameter.
At stop with low voltage Lv (LvS warn, no record). During operation with mid-low voltage Lv (LvA,
Lvd, Lvn error, will record).
Setting 62: when dEb function is enabled, the drive will execute dEb and record to the Pr.06-17 to
Pr.06-22 simultaneously.
Fault Output Option 1
Fault Output Option 2
Fault Output Option 3
Fault Output Option 4
Settings 0 to 65535 sec (refer to bit table for fault code)
These parameters can be used with multi-function output (set to 35-38) for the specific
requirement. When the fault occurs, the corresponding terminals will be activated (It needs
to convert binary value to decimal value to fill in Pr.06-23 to Pr.06-26).
0: No fault
1: Over-current during acceleration (ocA)
Call 1(800)985-6929 for Sales
deltaacdrives.com
software protection)
software protection)
software protection)
Fault Code
deltaacdrives.com
Chapter 11 Description of Parameter Settings|C200 Series
Bit0 Bit1 Bit2
current Volt. OL
●
11-88
sales@deltaacdrives.com
Factory Setting: 0
Bit3 Bit4 Bit5 Bit6
SYS FBK EXI CE
sales@deltaacdrives.com