Delta C200 Series User Manual page 128

Call 1(800)985-6929 for Sales
Settings
Cancel the setting of the
13
optimal accel./decel. time
Switch between drive settings 1
14
and 2
Operation speed command
15
form AVI
Operation speed command
16
form ACI
Operation speed command
17
form AUI
18 Emergency Stop (07-20)
19 Digital Up command
20 Digital Down command
21 PID function disabled
22 Clear counter
Input the counter value
23 (multi-function input command
6)
24 FWD JOG command
25 REV JOG command
FOCPG/TQCPG mode
26
selection
Call 1(800)985-6929 for Sales
deltaacdrives.com
Functions
Setti ng
fr eque ncy
MI - GND
O pe ra tio n
co mmand
Before using this function, Pr.01-44 should be set to 01/02/03/04 first.
When this function is enabled, OFF is for auto mode and ON is for
linear accel./decel.
When the contact is ON: use motor 2 parameters. OFF: use motor 1
parameters.
When the contact is ON, the source of the frequency will force to be
AVI. (If the operation speed commands are set to AVI, ACI and AUI at
the same time. The priority is AVI＞ACI＞AUI)
When the contact is ON, the source of the frequency will force to be
ACI. (If the operation speed commands are set to AVI, ACI and AUI at
the same time. The priority is AVI＞ACI＞AUI)
When this function is enabled, the source of the frequency will force to
be AUI. (If the operation speed commands are set to AVI, ACI and AUI
at the same time. The priority is AVI＞ACI＞AUI)
When the contact is ON, the drive will ramp to stop by Pr.07-20
setting.
When the contact is ON, the frequency will be increased and
decreased. If this function is constantly ON, the frequency will be
increased/decreased by Pr.02-09/Pr.02-10.
When the contact is ON, the PID function is disabled.
When the contact is ON, it will clear current counter value and display
"0". Only when this function is disabled, it will keep counting upward.
The counter value will increase 1 once the contact is ON. It needs to
be used with Pr.02-19.
When the contact is ON, the drive will execute forward Jog command.
When execute JOG command under torque mode, the drive will
automatically switch to speed mode; after JOG command is done, the
drive will return to torque mode.
When the contact is ON the drive will execute reverse Jog command.
When execute JOG command under torque mode, the drive will
automatically switch to speed mode; after JOG command is done, the
drive will return to torque mode.
When the contact is ON: TQCPG mode.
When the contact is OFF: FOCPG mode.
deltaacdrives.com
Chapter 11 Description of Parameter Settings|C200 Series
Descriptions
V ol tage
Fr eque ncy
x
11-29
sales@deltaacdrives.com
O FF
O N
ON
O N
sales@deltaacdrives.com
Ti me