Delta C200 Series User Manual page 291

Call 1(800)985-6929 for Sales
(Execute/Stop) is controlled by WPL editor.
When switching the page from PLC to PLC2, it will stop PLC. Again the motion of PLC
2.
(Execute/Stop) is controlled by WPL editor.
The control of external terminals follows the same method.
3.
NOTE
When input/output terminals (FWD REV MI1~MI8 MI10~15, Relay1, Relay2 RY10~RY15, MO1~MO2 MO10~MO11,)
are used in PLC program, they cannot be used in other places. Fro example, when PLC program (PLC1 or PLC2) is
activated, such as when it controls Y0, the corresponding output terminals Relay (RA/RB/RC) will be used. At this
moment, Pr.03.00 setting will be invalid since the terminal has been used by PLC. Refer to Pr.02-52, 02-53, 03-30 to
check which DI DO AO are occupied by PLC.
14.3.2 I/O Device Reference Table
Input device
Device X0
FWD REV MI1
1
1: I/O extension card
Output device
Device Y0
RY1 RY2
1
1: I/O extension card
Call 1(800)985-6929 for Sales
:
X1 X2 X3 X4
MI2 MI3
:
Y1 Y2 Y3 Y4
MO1 MO2
deltaacdrives.com
X5 X6 X7 X10
MI4 MI5 MI6 MI7
Y5 Y6 Y7 Y10
14-6
deltaacdrives.com
sales@deltaacdrives.com
Chapter 14 PLC Function |C200 Series
X11 X12 X13 X14
MI8
Y11 Y12 Y13 Y14
sales@deltaacdrives.com
X15 X16 X17
Y15 Y16 Y17