Delta C200 Series User Manual page 290

Call 1(800)985-6929 for Sales
14.3 Start-up
14.3.1 The Steps for PLC Execution
Please operate PLC functions by following the steps indicate below:
When using KPC-CE01 series digital keypad, switch the mode to PLC2 for program
download/upload:
A. Press MODE key and select 'PLC'.
B. Press 'UP' key and look for 'PLC2' then press 'ENTER'.
C. If succeed, display 'END' for one to two seconds and return to 'PLC2' page.
The PLC warning that is displayed before program downloaded to C2000 can be ignored, please
continue the operation.
1. Connection: Connect RJ-45 of AC motor drive to the computer by using RS485.
2. Run the program.
PLC
1.Disable
2.PLC Run
3.PLC Stop
When external input terminals (MI1~MI8) are set to PLC Mode select bit0 (51) or PLC Mode
select bit1 (52), it will force to switch to PLC mode regardless the terminal is ON or OFF.
Meanwhile, switching via keypad is disabled. Please refer to the chart below:
PLC Run (PLC 1)
PLC Stop (PLC 2)
Previous state
When KPE-LE02 execute PLC function:
When switching the page from PLC to PLC1, it will execute PLC. The motion of PLC
1.
Call 1(800)985-6929 for Sales
Disable
RS485
PLC Mode
Disable (PLC 0)
deltaacdrives.com
Run PLC
i AC d i
PLC function, select function 2 (PLC Run).
1: Disable (PLC0)
2: PLC Run (PLC1)
3: PLC Stop (PLC2)
Optional accessories: Digital keypad KPC-CE01, display
PLC function as shown in the ( ).
PLC Mode select bit1(52)
OFF
OFF
ON
ON
14-5
deltaacdrives.com
sales@deltaacdrives.com
Chapter 14 PLC Function |C200 Series
PLC Stop
C200
PLC Mode select bit0 (51)
OFF
ON
OFF
ON
sales@deltaacdrives.com