Delta C200 Series User Manual page 268

Call 1(800)985-6929 for Sales
13.3.3 Delta Defined Control Mode
There are two control modes.
1. Wiring for hardware (refer to chapter 13-2 Wiring for CANopen)
2. Operation source setting: set Pr.00-21 to 3 for CANopen communication control.
3. Frequency source setting: set Pr.00.20 to 6 (CANopen setting. If torque control or position
control is required, set Pr.0.02 to 2. Also set Pr.09.30 to 1(default setting) to allow new address
60XX to function, the old address 20XX can not support the control function for position and
torque.
4. Source of torque setting is set by Pr.11-33.
5. CANopen station setting: set Pr.09-36 (Range of setting is 1~127. When Pr.09-36=0, CANopen
slave function is disabled. ) (Note: If error occurred (CAdE or CANopen memory error) as station
setting is completed, press Pr.00-02=7 for reset.)
6. CANopen baud rate setting: set Pr.09.37 (CANopen Baud Rate: 1M(0), 500K(1), 250K(2),
125K(3), 100K(4) and 50K(5))
7. CANopen decode method setting: set Pr.09.40 to 0 (Delta decoding method). It provides two
decoding method by using Pr.09-30 and the default setting of the drive is in decoding method 2
(Pr.09-30=1).
8. Decoding method 1. In index 2020.01 enter 0002H for motor run; 0001H for motor stop. In index
2020.02 enter 1000, frequency will be 10.00Hz. Refer to Index 2020 and 2021 for more detail.
9. Decoding method 2. In index 2060.01 enter 0080H for motor switch on; enter 0x81 for motor run
to the target frequency. Various control mode options are available in Pr.00-40, select your
control mode.
Call 1(800)985-6929 for Sales
deltaacdrives.com
Chapter 13 CANopen Overview |C200 Series
13-11
deltaacdrives.com
sales@deltaacdrives.com
sales@deltaacdrives.com