Replacing Roll Media - MUTOH DrafStation User Manual

3.5 REPLACING ROLL MEDIA

Be sure to read and understand the safety warnings before handling the printer.
Notes
• To replace media on a Drafstation Pro when using the Take-up system, refer to the User's Guide of the
Take-up system.
Describes the replacement time and replacement method for roll media.
(1) Replacement time
Replace roll media if...
...the roll media runs out.
• The operation panel displays "End of Roll".
•
If the media runs out during printing, the plotter stops printing.
...you want to change the media type.
(2) Type
Notes
•
For types and details of roll media, refer to: "Options/Supplies"
(3) Replacement steps
To replace roll media, follow the procedure below. Note that the procedure consists of 2 parts.
1. Remove the installed roll media.
Step 1 : Verify that
•
the plotter has been switched ON,
• the plotter is in Normal mode, and
•
The plotter does NOT print.
Step 2 : Push the media hold lever (1) backward (lever up). See image below.
N°
1 Media hold lever
48
User's Guide DrafStation and Drafstation Pro
Name
Chapter 3: Basics
AP-75730, Rev. 2.1, 19/01/2009