Basic Settings - HEIDENHAIN ND 7000 Operating Instructions Manual

7
7.3.1

Basic settings

Selecting the Application
When putting the product into service, you can choose between the standard
application modes of Milling and Turning.
In its factory default setting, the product is already set to the Milling application
mode.
Activating the Software options
Additional Software options can be enabled on the product via a License key.
Requesting license key
You can request a license key by using the following procedure:
Reading out device information for the license key request
Creating a license key request
Reading out device information for the license key request
96
When you change the unit's application mode, then all of the axis
settings will be reset.
Tap Settings in the main menu
Tap Service
Open in the sequence
OEM area
Settings
In the Application drop-down list, select the Milling
application mode
You can view the enabled Software options on the overview page.
Further information: "Checking the Software options", Page 98
Tap Settings in the main menu.
Tap General
Tap Device information
An overview of the device information appears
The product designation, ID number, serial number, and
firmware version are displayed
Contact a HEIDENHAIN service agency and submit the
displayed device information in order to request a license key
for the product
The license key and the license file are generated and sent by
e-mail
Commissioning | Steps for commissioning
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020