HEIDENHAIN ND 7000 Operating Instructions Manual page 264

15
Parameters
Minimum spindle speed
Maximum spindle speed for
oriented spindle stop
Maximum spindle speed for
thread cutting
15.6.17 Outputs (S)
Path:
Parameters
Analog output
Analog output is inverted
Smax
Umax
Enable spindle CW
Enable spindle CCW
264
The switching functions are available only for units with ID number
1089179-xx.
Settings ► Axes ► S ► Outputs
Explanation
Definition of the minimum spindle speed
Setting range: 0 rpm ... 500 rpm
Default value: 50
Definition of the maximum spindle speed for oriented spindle
stop
Setting range: 0 rpm ... 500 rpm
Default value: 30
Definition of the maximum spindle speed for thread cutting
Setting range: 100 rpm ... 2000 rpm
Default value: 1000
Explanation
Assignment of the analog output according to pin layout
Default value: Not connected
If this function is active, the analog signal is inverted at the
output
Default value: not active
Definition of the Spindle speed attained with Umax
Setting range: 100 rpm ... 10000 rpm
Default value: 2000
The Maximum machine speed cannot be exceeded,
even if you have defined a higher feed rate for
individual axes.
Maximum voltage that is output at the analog output in order to
attain Smax
Setting range: 1000 mV ... 10000 mV
Default value: 9000
Assignment of the digital output for the clockwise spindle enable
according to pin layout
Default value: Not connected
Assignment of the digital output for the counterclockwise
spindle enable according to pin layout
Default value: Not connected
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Settings | Axes