HEIDENHAIN ND 7000 Operating Instructions Manual page 30

2
2.7 General safety precautions
The specific safety precautions required for the individual activities to be
performed on the product are indicated in the respective sections of these
instructions.
2.7.1 Symbols on the product
The following symbols are used to identify the product:
Symbol
30
The safety of any system incorporating the use of this product is the
responsibility of the assembler or installer of the system.
The product supports the use of a wide variety of peripheral devices
from different manufacturers. HEIDENHAIN cannot make any
statements on the specific safety precautions to be taken for
these devices. The safety precautions provided in the respective
documentation must be observed. If there is no documentation at
hand, it must be obtained from the manufacturers concerned.
Meaning
Observe the safety precautions regarding electricity and the
power connection before you connect the product.
Functional ground connection as per IEC/EN 60204-1. Observe
the information on installation.
Product seal. Breaking or removing the product seal will result
in forfeiture of warranty and guarantee.
Safety | General safety precautions
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020