HEIDENHAIN ND 7000 Operating Instructions Manual page 103

Commissioning | Steps for commissioning
Configuring the axes for encoders with a 1 V
The configuration procedure is the same for each axis. The procedure
will now be explained using one axis as an example.
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Tap Settings in the main menu
Tap Axes
Tap the axis name or Not defined if applicable
If applicable, select the axis name for the axis in the Axis
name drop-down list
Tap Axis type
Select the Linear axisAxis type
In order to switch to the previous axis, tap Back
Tap Encoder
Select the connection for the corresponding encoder from
the Encoder input drop-down list:
X1
X2
X3
Select the type of incremental signal from the Incremental
signal drop-down list:
1 Vpp: Sinusoidal voltage signal
11 µApp: Sinusoidal current signal
Select the encoder model from the Encoder model drop-
down list:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: A rotary axis is
displayed as a linear axis
Depending on the selection, enter further parameters:
For Linear encoder, enter the Signal period
(see " Linear encoders", Page 105)
For Angle encoder, enter the Line count (see "Angle
encoders and rotary encoders", Page 105), or
determine it using a teach sequence (see "Ascertaining
the line count per revolution", Page 111)
For an Angle encoder as linear encoder, enter the Line
count and the Mechanical ratio
Confirm each input with RET
For Angle encoder, select the Display mode if applicable
Tap Reference marks
Select the reference mark from the Reference mark drop-
down list:
None: There is no reference mark
One: The encoder has one reference mark
Coded: The encoder has distance-coded reference marks
or 11 µA interface
PP PP
7
103