Status Bar; Operating Elements Of The Status Bar - HEIDENHAIN ND 7000 Operating Instructions Manual

6
Setting the gear stage for gear spindles
If your machine tool uses a gear spindle, then you can select the gear stage used.
S
1
6.10

Status bar

In the status bar, the product shows the feed rate and traversing speed. The
operating elements of the status bar also give you direct access to the preset table
and tool table, as well as to the stopwatch and calculator features.
6.10.1

Operating elements of the status bar

The status bar provides the following operating elements:
82
The following information applies only to units with ID number
1089179-xx.
The selection of the gear stages can also be controlled via an external
signal.
Further information: "Spindle axis S", Page 263
In the working space, drag the S axis key to the right
Tap Gear stage
The Set gear stage dialog appears
Tap the desired gear stage
Tap Confirm
The selected gear stage is now adopted as the new value
Drag the S axis key to the left
The icon for the selected gear stage appears next to the S
axis key
If the desired spindle speed cannot be attained with the selected gear
stage, then the gear stage icon will flash with an upward pointing arrow
(higher gear stage) or with a downward pointing arrow (lower gear
stage).
The status bar and the optional OEM bar are not available in the
Programming menu.
Basic operation | Position display
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020