Figure 57: Schematic Display Of The Rectangular Pocket Block - HEIDENHAIN ND 7000 Operating Instructions Manual

13
Rectangular pocket block

Figure 57: Schematic display of the rectangular pocket block

Parameter
Clearance height
Depth
X coordinate of
center
Y coordinate of
center
Side length in X
Side length in Y
Direction
Finishing allowance
218
Description
Z plane above the workpiece in which the tool is
allowed to move at maximum speed
Target depth for milling in the tool axis
Default: Through-hole drilling
Center of the rectangular pocket in the X plane
Center of the rectangular pocket in the Y plane
Length of the rectangular pocket in the X-axis direction
Length of the rectangular pocket in the Y-axis direction
Direction in which the rectangular pocket is roughed
out (clockwise or counterclockwise)
Default: counterclockwise
Amount of material that is to be left remaining around
the rectangular pocket and will be removed in the last
pass
Programming (software option) | Block types
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020