HEIDENHAIN ND 7000 Operating Instructions Manual page 221

Programming (software option) | Creating a program
13.3.4 Deleting blocks
13.3.5 Saving a program
13.4 Using the simulation window
The simulation window visualizes the selected block. You can also use the
simulation window to check a created program step by step.
The following options are available on the view bar:
Control
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Tap Delete on the toolbar
The blocks contained in the program are marked with a
Delete symbol
Tap the Delete symbol for the blocks you want to delete in
the program
The selected blocks are deleted from the program
Tap Delete on the toolbar again
Tap Save program in the program management
The program is saved
Function
Graphic
Display of simulation and blocks
Position
Display of position values and blocks
13
221