HEIDENHAIN ND 7000 Operating Instructions Manual page 192

11
11.2 Block types
You can use the following block types for machining in the MDI mode:
Positioning functions
Machining patterns
11.2.1 Positioning
You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
The following parameters are available:
Positioning block
Parameter
R0
R+
R–
11.2.2 Machining patterns
You can define various machining patterns to machine complex shapes. From the
data you enter, the product calculates the geometry of the machining patterns and
optionally displays them in the simulation window.
192
You can load the current axis position with Actual position capture into
the appropriate input fields.
Description
Tool radius compensation disabled (default setting)
Positive tool radius compensation; the traverse path is
increased by the tool radius (outside contour)
Negative tool radius compensation; the traverse path is
decreased by the tool radius (inside contour)
Incremental position value, i.e. the position value is
referenced to the actual position
Through-hole drilling without a specified position value
Before defining a machining pattern, you must
Define a suitable tool in the tool table
Select the tool on the status bar
Further information: "Creating a tool table", Page 147
You can load the current axis position with Actual position capture into
the appropriate input fields.
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
MDI mode | Block types