HEIDENHAIN ND 7000 Operating Instructions Manual page 184

10
10.3.6 Example 4: Setting a preset in the middle of the workpiece
The following probing steps are required in order to set the preset in the middle of
the workpiece:
Probing
function
184
steps
Probe the edges in Y+ direction and
the Y– direction
Probe the edges in the X+ direction
and X– direction
Probe the edge in the Z– direction
The product defines the preset in the
middle of the workpiece
Manual operation | Defining presets
Figure
2
1
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
M
1
2
M