HEIDENHAIN ND 7000 Operating Instructions Manual page 257

Settings | Axes
15.6.10 Encoder
Settings ► Axes ► <Axis name> ► Encoder
Path:
Settings for encoders with interfaces of the EnDat 2.2 type
Parameter
Encoder input
Interface
ID label
Diagnosis
Encoder model
Mechanical ratio
Reference point displacement
Settings for encoders with interfaces of the type 1 V
Parameter
Encoder input
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Explanation
Assignment of the encoder input to the axis of the product
Settings:
Not connected
X1
X2
X3
Further information: "Device overview", Page 47
Automatically detected EnDat interface type
Information about the encoder that was read out from the
electronic ID label
Results of encoder diagnostics
Connected encoder model
Settings:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: Rotary axis is displayed as
linear axis
Default value: Depending on the connected encoder
For display of a rotary axis as a linear axis:
traverse path in mm per revolution
Setting range: 0.1 mm ... 1000 mm
Default value: 1.0
Configuration of the offset between the reference mark and the
zero point
Further information: "Reference point displacement",
Page 261
or 11 μA
PP
Explanation
Assignment of the encoder input to the axis of the product
Settings:
Not connected
X1
X2
X3
Further information: "Device overview", Page 47
PP
15
257