HEIDENHAIN ND 7000 Operating Instructions Manual page 262

15
15.6.14 Segmented linear error compensation (SLEC)
Path:
Parameters
Compensation
Table of supporting points
Create table of supporting points
15.6.15 Create table of supporting points
Path:
Parameters
Number of supporting points
Spacing of the supporting points
Start point
Create
262
Settings ► Axes ► <Axis name> ► Error compensation ►
Segmented linear error compensation (SLEC)
Settings ► Axes ► <Axis name> ► Error compensation ►
Segmented linear error compensation (SLEC) ► Create table of supporting points
Explanation
Mechanical influences on the axes of the machine are
compensated
Settings:
ON: Compensation is active
OFF: Compensation is not active
Default value: OFF
When Compensation is active, then the Table of
supporting points cannot be edited or created.
Opens the table of supporting points for manual editing
Opens the menu for creating a new Table of supporting points
"Create table of supporting points",
Further information:
Page 262
Explanation
Number of supporting points on the mechanical axis of the
machine
Setting range: 2 ... 200
Default value: 2
Spacing of the supporting points on the mechanical axis of the
machine
Default value: 100.00000
The start point defines the position starting from which the
compensation is applied to the axis
Default value: 0.00000
Creates a new table of supporting points based on the entries
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Settings | Axes