Configuring M Functions - HEIDENHAIN ND 7000 Operating Instructions Manual

7
7.3.4

Configuring M functions

Depending on the configuration of the machine tool, you can also use M functions
(machine functions) for machining operations. You can use M functions to
influence the following factors:
functions on the machine tool, such as switching the spindle rotation and
coolant on and off
the path behavior of the tool, and
the program execution
You can use all M functions as block type in programming and program run.
Further information:
A graphic can also be optionally displayed for calling the M functions in the
program run.
Further information:
The product differentiates between standard M functions and the manufacturer-
specific M functions.
Standard M functions
The product supports the following standard M functions (oriented to DIN 66025/
ISO 6983):
Code
M2
M3
M4
M5
M8
M9
M30
These M functions are independent of the machine; some M functions however
depend on the machine tool configuration (e.g. spindle functions).
Manufacturer-specific M functions
The product also supports manufacturer-specific M functions with the following
characteristics:
Number range definable from M100 to M120
Function depends on the machine manufacturer
Use in the button of the OEM bar
Further information:
112
The following information applies to units with ID number 1089178-xx
only to a limited extent.
"Machine functions", Page 214
"Configuring M functions", Page 276
Description
Program STOP, spindle STOP, coolant OFF
Spindle rotation in clockwise direction
Spindle rotation in counterclockwise direction
Spindle STOP
Coolant ON
Coolant OFF
Program STOP, spindle STOP, coolant OFF
The manufacturer-specific M functions M100 to M120 are only available
if the connected output has been previously configured.
Further information: "Configuring M functions", Page 255
"Configuring the OEM bar", Page 115
Commissioning | Steps for commissioning
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020