HEIDENHAIN ND 7000 Operating Instructions Manual page 172

9
9.10.2 Programming the tool
9.10.3 Programming the row of holes
172
Quick Start | Programming a row of holes (programming)
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Tool call block
type
Tap Tool number
The Tools dialog appears
Tap Drill 5.0
The associated tool parameters are applied automatically
The Tools dialog is closed
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Spindle speed
block type
In Spindle speed, enter the value 3000
Confirm the entry with RET
Tap Add block on the toolbar
A new block is inserted below the current position
In the Block type drop-down list, select the Row of holes
block type
Enter the following values:
X coordinate of 1st hole: -90
Y coordinate of 1st hole: -45
Holes per row: 4
Hole spacing: 45
Angle: 0°
Depth: -13
Number of rows: 3
Row spacing: 45
Fill mode: bolt hole circle
Confirm each entry with RET
Tap Save program in the program management
The program is saved
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020