HEIDENHAIN ND 7000 Operating Instructions Manual page 235

Settings | General
General
15.2
This chapter describes settings for configuring the operation and display and for
setting up printers.
15.2.1 Device information
Settings ► General ► Device information
Path:
The overview displays basic information about the software.
Parameter
Product designation
Part number
Serial number
Firmware version
Firmware built on
Last firmware update on
Free memory space
Free working memory (RAM)
Number of unit starts
Operating time
15.2.2 Screen
Settings ► General ► Screen
Path:
Parameter
Brightness
Energy-save-mode timeout
Quit the energy saving mode
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Displays the information
Product designation of the product
ID number of the unit
Serial number of the product
Version number of the firmware
Firmware creation date
Date of most recent firmware update
Free memory space in the internal storage location Internal
Free RAM on the system
Number of times the product was started up with the current
firmware
Operating time of the product with the current firmware
Explanation
Brightness of the screen
Setting range: 1 % ... 100 %
Default setting: 85 %
Time until energy-save mode is activated
Setting range: 0 min ... 120 min
If the value is set to 0, the power-saving mode is deactivated
Default setting: 30 minutes
Required actions to reactivate the screen
Tap and drag: Touch the touchscreen and drag the arrow
upwards from the lower edge
Tap: Touch the touchscreen
Tap or axis movement: Touch the touchscreen or move the
axis
Default setting: Tap and drag
15
235