HEIDENHAIN ND 7000 Operating Instructions Manual page 197

MDI mode | Block types
When machining a rectangular pocket in MDI and Program Run modes of
operation, the following applies:
Approaching the starting position is at clearance height at rapid traverse
If a target depth was defined, positioning is at Clearance height at the end of
the machining operation
11.3 Executing blocks
You can execute a positioning function or select a machining pattern and execute
this block.
If enabling signals are missing, the running program is halted and the
drives of the machine are stopped.
Further information:
Executing blocks
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Manufacturer's documentation for the machine
Tap Create on the status bar
A new block is displayed
or
The last programmed MDI block is loaded along with all of its
parameters
Select the desired block type from the Block type drop-down
list
Based on the block type, define the relevant parameters
To load the current axis position, tap Actual position capture
in the appropriate input fields
Confirm each input with RET
To execute the block, tap END
The positioning aid is displayed
If the simulation window is activated, the current block is
visualized
Depending on the block, user intervention may be required;
the wizard will display the relevant instructions
Follow the instructions in the wizard
11
197