HEIDENHAIN ND 7000 Operating Instructions Manual page 111

Commissioning | Steps for commissioning
Ascertaining the line count per revolution
For angle encoders with interfaces of the type 1 V
teach sequence to ascertain the exact line count per revolution.
The ascertained line count remains stored if you select a different
display mode after the teach sequence.
Further information:
11 A ", Page 257
PP
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Tap Settings in the main menu
Tap Axes
Tap the desired axis designation or Not defined, if applicable
If applicable, select the name of the axis in the Axis name
drop-down list.
Tap Encoder
From the Encoder model drop-down list, select the Angle
encoder type
For Display mode select the - ∞ ... ∞ option
Tap Reference marks
Select one of the following options from the Reference mark
drop-down list:
None: There is no reference mark
One: The encoder has one reference mark
In order to switch to the previous axis, tap Back
To start the teach sequence, tap Start
The teach sequence is started and the wizard is displayed
Follow the instructions of the wizard
The line count determined during the teach sequence is
transferred to the Line count field
"Settings for encoders with interfaces of the type 1 V
or 11 μA
you can use a
PP PP
PP
or
111
7