HEIDENHAIN ND 7000 Operating Instructions Manual page 101

Commissioning | Steps for commissioning
Activating the reference mark search
The product uses the reference marks to reference the machine table to the
machine. If the reference mark search has been activated, a wizard appears on
startup of the product and asks the user to move the axes for the reference mark
search.
Requirement:
configured in the axis parameters.
The reference mark search does not need to be performed for serial
encoders with EnDat interface, because the axes are automatically
homed.
The automatic reference mark search on startup of the product can be
canceled depending on the configuration.
Further information:
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
The installed encoders have reference marks that have been
"Reference marks (Encoder)", Page 259
Tap Settings in the main menu
Tap Axes
Open in the sequence
General settings
Reference marks
Use the ON/OFF slide switch to activate the Reference mark
search after unit start function
The reference marks must be traversed every time the
product is started
The functions of the product will only be available after the
reference mark search has been completed
The Reference symbol stops blinking upon successful
completion of the reference mark search
Further information:
display", Page 80
"Operating elements of the position
7
101