HEIDENHAIN ND 7000 Operating Instructions Manual page 148

8
Creating a tool
Deleting a tool
148
Tap Tools on the status bar
The Tools dialog box appears
Tap Open table
The Tool table dialog box appears
Tap Add
Enter a name in the Tool type input field
Confirm the entry with RET
Tap the input fields one after the other, and enter the
corresponding values
Change the unit of measure in the selection menu, if required
The entered values are converted
Confirm the entry with RET
The defined tool is added to the tool table
To protect the entry for a tool from accidental changes or
deletion, tap the Lock symbol next to the tool's entry
The symbol changes and the entry is locked
Tap Close
The Tool table dialog box is closed
Tap Tools on the status bar
The Tools dialog box appears
Tap Open table
The Tool table dialog box appears
To select one or more tools, tap the checkbox in the relevant
row
The active checkbox is highlighted in green
The entry for a tool can be locked to prevent
accidental changes or deletion.
Tap the Unlock symbol next to the entry
The symbol changes and the entry is unlocked
Tap Delete
A message appears
Close the message with OK
The selected tool is deleted from the tool table
Tap Close
The Tool table dialog box is closed
Setup | Single steps for setup
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020